|
Melbourne Desk
|
|
Written by Administrator
|
|
Friday, 13 February 2009 08:33
|
Class H Sports Model Austin 7
The Class ‘H' Sports Model Austin Seven is the second ‘found' model from CMC Motor Bodies. The penchant
for French styling is again evident.
The following images give a potted description of CMC's design/build method.
Joss Campbell has evolved this method through his extensive repertoire of car building.
In the creation of the ‘Dieppe' Model I may have been the apprentice, but now I get to do the big picture with
an ever watchful partner. Huge gratitude to Joss for being that part of CMC. As a collaborative process they can't get much better.
|
Above: A bottom and upper curve are described on a ply
floor. A sill is fixed and uprights half jointed to the whole.
Strapping describes the desired curve of upper dimension.
3mm ply is temporarily fixed, onto which is drawn a profile
that serves as a pattern for building up the superstructure
|
|
Above: A box is built to traverse the back axle. Made of
9mm ply. The rear floor of original ply floor is removed.
Two laminated beams previously set up against the ply
side panels have been fitted.
|
|
Above: Cross members fix all widths while quarter inch
stringers tie front and rear sections and the whole begins
to feel very strong.
|
|
Above: A laminated curve is set to form upper curve of the
back section.
|
|
Above: The cutouts are roughly removed in line with
laminates that have been fixed diagonally to facilitate
the desired curve.
|
|
Above: A crude set up of side panels set up with a
fortuitously fitting ‘Nippy' bonnet top. The nature of the
staggered seating is seen. This is a very useful feature
in a narrow bodied ‘7'. Austin used it in the Super Sports
and the French used it extensively.
|
|
Above: The battery box sited behind drivers seat. The
transmission tunnel is fitted. All steel is 22 gauge.
|
|
|
Above: A firewall is folded, sided and spot welded and bonnet land brought up.
Challenging!
|
|
|
Valances formed with a joggle to act as land for bonnet sides
|
{mospagebreak}
Below: Inside the cockpit which shows an extended curved gear lever.
A nod to Austin’s 1925 Supercharged racer.
Above: The instrument panel is fashioned and fitted
The side panels are permanently attached as is the rear floor
|
Above: The upper rear ply panels are glued to the frame. After fettling
the body will be covered in canvas.
The side panels are permanently attached as is the rear floor
|
|
Above: Where it’s heading: A homage to Marcel Violet and the
Huascar. .
But without the exhaust gases discharging at the driver’s right
shoulder!
|
|
|
Above: Bonnet sides are made and hinged to ‘original’ top
|
|
|
Last Updated on Sunday, 06 March 2011 05:57
|
